Super-micro-computer IRV-3702 Bedienungsanleitung

User's Manual for the IRV-3702 Single Board Computer with AGP/VGA & Ethernet MCSI PART NO. 89000 IRV-3702 All-In-One Single Boar

4 pulse to port 61H to clear the interrupt for the next byte. Refer to Appendix D for the keyboard connector location and pin assignments. MOUSE PORT

5 EIDE HARD DISK PORT The IRV-3702 SBC contains two PCI Extended Integrated Drive Electronics (EIDE) Ports that directly interface up to four hard di

6 ETHERNET PORT The IRV-3702 SBC contains a Realtek RTL8139 highly integrated single-chip Fast Ethernet controller. The RTL8139 provides 10Mbps and 1

7 SECTION 3 - SETUP The IRV-3702 SBC uses the latest AMI Plug-n-Play BIOS that contains an internal Setup Utility for configuring the system. The BI

8 SECTION 4 - USING THE PROMDISK-CHIP DISK EMULATOR The IRV-3702 SBC includes a 32-pin socket that supports the MCSI PROMDISK-Chip disk emulator whic

9 SECTION 5 - INSTALLATION This section describes the procedures for installing the IRV-3702 All-In-One Single Board Computer into your system. The

10 2. Push the PROMDISK-Chip into the socket carefully until it is fully seated. 3. Check to make sure the PROMDISK-Chip is installed securely, and

11 APPENDIX A - SPECIFICATIONS This appendix lists the specifications for the IRV-3702 All-In-One Single Board Computer. CPU: Supports: Intel Cele

12 APPENDIX B - BOARD OUTLINE 1CN1CN2CN4CN11JP15JP12.Denotes pin 1CN10CN18J1CN3CN7CN12CN8CN17JP7JP3CN13JP14B

13 APPENDIX C - MEMORY AND I/O MAPS The following is the memory map for the IRV-3702 SBC. The addresses are fully PC/AT compatible, unless otherwi

Revised January 14, 2000 Revision 1.1 Changes are made periodically to the information contained herein; these changes will be incorporated into

14 APPENDIX D - CONNECTORS CN8 Keyboard Header/Connector Pin Signal 1 KBCLK 2 KBDATA 3 N/C 4 GND 5 +5VDC CN18 Keyboard/Mouse Connector (

15 CN1 & CN3 IDE Hard Disk Port Connectors Pin Signal Pin Signal 1 IDERST/ 2 GND 3 IDED7 4 IDED8 5 IDED6 6 IDED9 7 IDED5 8 IDED1

16 CN12 Serial Port #1 9-pin Sub D Connector Pin Signal Name 1 CARRIER DETECT #1 2 RECEIVE DATA #1 3 TRANSMIT DATA #1 4 DATA TERMINA

17 CN7 IDE LED Header/Connector Pin Signal Name Description 13 IDE LED Connect to IDE LED anode (-) 15 +5VDC Connect to IDE LED cathode (+) C

18 APPENDIX E - CONFIGURATION JUMPERS JP3 &JP15 CPU Clock Jumpers BUS JP15 JP3 JP3 FREQUENCY FS2 FS1 FS0 66MHz 2-3 1-3 2-4 100MHz 1-2

19 JP4 Clear CMOS Setup Jumper OFF Normal Operation (Default) 3-4 Clear CMOS Setup JP7 PS/2 Mouse Jumper ON Enabled using IRQ12 OFF Disabled

20 APPENDIX F - BIOS ERROR BEEP CODES During the POST (Power On Self Test) routines, which are performed each time the system is powered on, errors

PREFACE This manual provides information about the MCSI IRV-3702 All-In-One Single Board Computer. This information is intended for users who must i

Table of Contents Section 1 - Introduction___________________________________________________________________ 1 Features...

1 SECTION 1 - INTRODUCTION The MCSI IRV-3702 Celeron All-In-One Single Board Computer (SBC) contains all the basic elements found in a high-performa

2 SECTION 2 - SYSTEM DESCRIPTION The following sections describe the major system features of the IRV-3702 All-In-One Single Board Computer. PROCESS

3 INTERRUPT CONTROLLER The IRV-3702 SBC has the equivalence of two 82C59A interrupt controllers included in the System Controller chip. The controll